Not reaching full boost

[hahn><boost]

I just went for a drive this morning and I was watching my boost gauge normally the needle is buried at 140kpa and for some reason the most I could get was 130kpa only once other times it was 90kpa. wtf is going on here.
There was also a few drops of oil on the front of my intake plenum.

 

[06ion2coup]

leak?

 

[hahn><boost]

well I found whats wrong... cracked my intake plenum. F%%$

---------- Post added at 09:45 AM ---------- Previous post was at 09:41 AM ----------

I hope I can just get the crack rewelded in town here. I cant wait another 3 months for a new one to get here.

 

[YelloEye]

It cracked? wtf first I've heard of that happening.

 

[hahn><boost]

Im just going to jb weld it. lol

---------- Post added at 03:54 PM ---------- Previous post was at 02:05 PM ----------

is there any reason why I shouldnt use jb weld as a temporary fix? I mean will it heat up and some how melt and make its way in to my engine?

 

[BIRDMAN]

Can you post pics?

 

[YelloEye]

Im just going to jb weld it. lol

---------- Post added at 03:54 PM ---------- Previous post was at 02:05 PM ----------

is there any reason why I shouldnt use jb weld as a temporary fix? I mean will it heat up and some how melt and make its way in to my engine?

JB Weld should do just fine up to 24psi, I cannot say after that. There's plenty of people running it on their stock SS/TC intercoolers after taking off the condenser bar and filling the holes with it.

 

[hahn><boost]

Well Im tuned to 19.5 psi(130kpa) my boost gauge only goes to 20psi(140kpa) and its burried. so Im not sure whats with that maybe cause its a manual boost controller. So Im really not sure how much boost Im running.

---------- Post added at 04:38 PM ---------- Previous post was at 04:26 PM ----------

http://i1179.photobucket.com/albums/x388/marc435/intakecrack002.jpg

http://i1179.photobucket.com/albums/x388/marc435/intakecrack001.jpg

 

[YelloEye]

oh damn, that's a Hahn warranty claim my friend. Don't mess with it just contact them ASAP and see what they're going to do about it.

 

[hahn><boost]

I hope I dont have to send this one to them before they send me a new one I dont like down time.

---------- Post added at 05:02 PM ---------- Previous post was at 05:00 PM ----------

weld obviously not x-rayed