09 Cobalt LS - New owner, some strange issues

Carve

Junior Member
Joined
Apr 9, 2015
Posts
4
Reaction score
0
I've just purchased a used 09 Cobalt LS from my father in-law, he told me of an issue prior to me purchasing it, the issues I have currently are;

- Car starts, tries to idle, bogs out and dies.
- Wipers stay on (unless relay is pulled under hood) - Replaced wiper motor and switches - issue still exists.

The car ran fine up until today, nothing has changed from now to then except the wiper motor itself. Which was known to be in working condition before I installed it. I was told it could be a few different things causing this, BCM, Wiring Issue, Switch, and/or Motor. I've replaced two of the four issues but I honestly would rather stop wasting my money at this point.

Thanks for your time and :sorrysign:
 
Last edited:

Carve

Junior Member
Joined
Apr 9, 2015
Posts
4
Reaction score
0
Any codes on in the computer?

Current Fault Log
------------------
P0230: Fuel Pump Primary Circuit
P0420: Catalyst System Efficiency Below Threshold (Bank 1)
 
Last edited:

YelloEye

Super Moderator
Staff member
Joined
Jul 18, 2009
Posts
7,601
Reaction score
23
Location
Renton, WA
All your fuses OK? That looks like a fuel pump that's not working.
 

Carve

Junior Member
Joined
Apr 9, 2015
Posts
4
Reaction score
0
All your fuses OK? That looks like a fuel pump that's not working.

Haven't checked every fuse yet. I went out and started it up though and it ran fine for a few minutes.. I tried moving it some and it moved, however it did finally die out after I moved about 30 yards. I quickly started it and reversed it back in front of my house.
 

Carve

Junior Member
Joined
Apr 9, 2015
Posts
4
Reaction score
0
Odd. I don't know exactly what to check off hand.

Fuses all checked out fine.

I was told it could be the BCM or PCM? How would I go about testing this?

Also the wipers seem to still be acting up, same issue unless I pull the relay they continue to run at the same speed. New motor and new column switch (again) and same issues :(
 

YelloEye

Super Moderator
Staff member
Joined
Jul 18, 2009
Posts
7,601
Reaction score
23
Location
Renton, WA
I wouldn't know where to begin with the BCM and ECM diag. Sorry.
 

roosterk0031

Full Access Member
Joined
Apr 28, 2014
Posts
101
Reaction score
0
Location
Iowa
My 2010 when got below 20dF hazards would start flashing and wouldn't start. New BCM at $600 at dealer fixed it. Also had numerous TPMS and air bag lights that have since gone away. An expensive part swap to just check though. The dealer could wiggle it and change simptoms before they agreed to replace so give that a try.
 
Last edited:

Members online

Forum statistics

Threads
7,442
Posts
156,482
Members
4,388
Latest member
Bqueen84

Latest posts

Top